Fujitsu SPARC EnterpriseM3000 User Manual

2-188 SPARC Enterprise Mx000 Servers XSCF User’s Guide • January 2012
2. Use the setdomainmode(8) command to disable automatic boot.
3. Use the showdomainmode(8) command to confirm that autoboot is off. Also, to
apply the setting to the domain, restart the domain.
Specifying the CPU Operational Mode
Note – In the M3000 server, CPU operational mode cannot be configured.
■ Command operation
1. Power off the domain.
2. Use the showdomainmode(8) command to specify the CPU operational mode.
<Example> Disable automatic boot for domain ID 0.
XSCF> setdomainmode -d 0 -m autoboot=off
Diagnostic Level :max -> -
Secure Mode :on -> -
Autoboot :on -> off
CPU Mode :auto -> -
The specified modes will be changed.
Continue? [y|n]:y
configured.
Diagnostic Level :max
Secure Mode :on (host watchdog: available Break-signal:non-receive)
Autoboot :off (autoboot:off)
CPU Mode :auto
XSCF> showdomainmode -d 0
Host-ID :0f010f10
Diagnostic Level :max
Secure Mode :on
Autoboot :on
CPU Mode :auto

Fujitsu SPARC EnterpriseM3000 Specifications

General

Brand	Fujitsu
Model	SPARC EnterpriseM3000
Category	Server
Language	English