5. MAINTENANCE, TROUBLESHOOTING
5-14
1305 No speed data. Please check speed
source or enter manual speed value
in Parameter Setup.
Check the speed source or enter the speed manu-
ally.
1307 No wind data Check wind sensor.
1309 Wind data is shifted. Wind data has changed abruptly. Check wind sen-
sor.
1311 No NAV data. Wait for 1 seconds. Check nav data sensor.
1315 Degradation of NAV data quality. Check nav data sensor.
1317 No position data Check position-fixing equipment.
1801 EVC Interface error Communication error between the processor unit
and IPS interface unit or NMEA data converter.
Check the connection with IPS interface unit or
NMEA data converter.
1803 No contact with EVC. Communication error with the EVC system. Check
the connection with the EVC system
1901 Rate sensor error Check rate sensor.
1903 Backup error All user and engineer default settings are restored.
Reenter installation settings.
1905 Initializing heading sensor. This takes
two minutes, please wait.
The heading sensor is initializing. Wait approx. two
minutes until the heading sensor completes initial-
izing.
Fail
0001 Drive unit error. Please turn OFF and
check drive circuit.
Turn off power
0003 Drive unit overloaded. Please turn
OFF and check drive circuit.
Turn off power.
0005 Drive unit is overheated. Please turn
OFF and check drive circuit.
Temperature of drive circuit is higher than 80°C
(176°F). Turn off power.
0007 Bypass/clutch drive error. Please turn
OFF and check drive circuit.
Bypass/clutch error. Turn off power.
0009 Bypass/clutch is overloaded. Please
turn OFF and check drive circuit.
Bypass/clutch overload. Turn off power.
0011 Bypass/clutch is shorted out. Please
turn OFF and check drive circuit.
Bypass/clutch is shorted. Turn off power.
0013 Rudder drive error Turn off power.
0017 Rudder angle error Turn off power.
0019 EVC interface fail. System error of the IPS interface unit or NMEA data
converter. Turn off power, and then check the con-
dition of the IPS interface unit or NMEA data con-
verter.
0301 Communication error No communication between processor unit and all
control units. Turn off power.
Notice
2001 Input voltage is under limit Input voltage under limit. Check power supply.
2003 Input voltage is over limit Input voltage over limit. Check power supply.
2101 NAV mode parameter error Invalid parameter entered in NAV mode. Reenter
parameter.
2105 Start to turn by fishing mode Boat is starting to turn after dodge operation.
2107 Circle mode stopped Circle mode was stopped.
2109 Mode was changed. Steering mode changed.
Error
no.
Error message Meaning, remedy
To Next Page
Loading...
