7. INITIAL SETTINGS
7-2
5. Press the key to open the [Operation Mode] menu.
6. The cursor is selecting [Installation]; push the Course control knob.
The [Installation Menu] window appears.
Note 1: The items on the [Installation Menu] window change according to your
system.
Note 2: The [Installation Menu] window can be opened from the STBY mode by
pressing the Course control knob three times while holding down the key.
7. Follow the procedures in the remaining sections (in the order shown) of this chap-
ter to set up the NAVpilot.
Operation Mode
Installation
Demo Slide Show
Simulator
Prev Next
Installation Menu
Language: English(USA)
Units Setup
Display Setup
Ship’s Characteristics
Rudder Limit Setup
Rudder Test
Set Center Rud. Pos.
: No*
: No*
: No*
*: “No” is replaced with “Done” when respective setup is successfully completed.
To Next Page
Loading...
