Furuno NAVpilot-711C

To Next Page

To Previous Page

7. INITIAL SETTINGS

7-46

This page is intentionally left blank.

Main Page

Table of Contents6
Foreword10
System Configuration12
Equipment Lists13
Operational Overview15
Controls15
How to Turn the Power On/Off16
How to Power the System16
How to Power off the System16
How to Adjust the Brilliance17
How to Set the Display Color17
How to Select a Display18
Graphic Displays18
Numerical Display21
How to Select the Display Data22
How to Select the Display Data with the Key Operation (STBY Mode Only)24
Steering Modes25
STBY Mode25
AUTO Mode25
How to Get the AUTO Mode26
Advanced AUTO Mode27
NAV Mode28
How to Get the NAV Mode29
Sailing Method for the NAV Mode30
Waypoint Switching Method31
How to Set the Steering Behavior of Your Boat after You Arrive to a Waypoint32
Response Feature33
How to Activate the Auto Response Feature33
How to Activate the Manual Response Feature33
TURN Mode34
How to Select a Normal Turn and Start the Turn34
Types of Normal Turns35
Fishhunter37
How to Select a Fishhunter37
Mode37
Turn and Start the Turn37
Types of Fishhunter ™ Turns40
SABIKI Mode (Outboard Vessels Only)45
How to Use the SABIKI Mode46
How to Adjust the SABIKI Mode Response47
Rudder Drive Settings for the SABIKI Mode47
How to Navigate to a TLL Position48
DODGE Mode49
How to Dodge in the AUTO and NAV Modes49
How to FU Dodge in the STBY Mode49
How to NFU Dodge in the STBY Mode49
REMOTE Mode50
Dial-Type Remote Controller (FAP-5551, FAP-5552)50
Lever-Type Remote Controller (FAP-6221, FAP-6222)51
Dodge-Type Remote Controller (FAP-6231, FAP-6232)52
WIND Mode (for Sailboats)53
How to Get the WIND Mode53
Wind Angle Mode54
TACK Mode55
Tacking in WIND Mode (WIND TACK)57
How to Reverse a Heading Change Using the Keys/Knob60
OVRD Mode (for EVC System)61
Safe Helm Mode62
Power Assist Mode64
Alarms67
Alarm Menu67
Alarm Buzzer68
Buzzer Interval68
Watch Alarm69
Deviation Alarm69
XTE Alarm70
Arrival Alarm70
Speed Alarm71
Depth Alarm71
Water Temperature Alarm72
Trip Distance Alarm, Trip Distance Reset73
How to Set the Trip Log Alarm73
How to Reset the Trip Distance73
Wind Alarms (for Sailboats)74
Heading Change Alarm74
Wind Deviation Alarm75
True and Apparent Wind Speed Alarm75
Alarm Log76
User Menu77
Parameter Setup77
Sea State77
Trim Gain80
Speed Calculation81
Rudder Drive Level (for Fantum Feedback ™ )81
Net Towing82
Course after Operation of a Remote Controller83
Nav Data Source84
Navnet Vx2 Synchronization85
Data Source Setup85
Sensor Sync85
Data Source Selection85
System Setup Menu86
Menu Shortcuts88
How to Create a Menu Shortcut88
How to Delete a Menu Shortcut88
Maintenance, Troubleshooting89
Preventive Maintenance89
Replacement of Fuse90
Diagnostics90
Diagnostic Menu90
Processor Unit Test91
Control Unit Test92
EVC Interface Test92
NMEA0183 Test93
CAN Bus Test93
Key Test94
Screen Test94
Rudder Test95
Helm Sensor Test99
System Data100
Messages100
Message Pop-Up Display100
Message Board101
Message Description101
Sensor in Use Display103
Installation and Wiring105
Installation105
Installation Location105
When FAP-7011 Is Replaced with FAP-7011C106
How to Install the Control Unit107
Wiring109
Wiring Notices110
Connection with the Processor Unit111
Initial Settings113
How to Select Language and Units, Open the Installation Menu Window113
Display Setup115
Ship's Characteristics Menu116
Dockside Setup Menu117
Dockside Setup for the Rudder Reference Unit117
Dockside Setup for Fantum Feedback123
How to Set the Safe Helm Mode and Power Assist Mode127
Confirmation of the Dockside Setup131
CAN Bus Port Setup135
NMEA0183 Port Setup137
Data Source Setup139
Universal Port Setup140
GENERAL in Port Setup140
GENERAL out Port Setup141
Sea Trial142
How to Calibrate the Compass (PG-500/PG-700)143
How to Set the Rudder Deadband145
Data Calibration146
Parameter Setup Menu147
Sea State147
Trim Gain150
Speed Calculation151
AUTO Option Menu151
NAV Option Menu152
How to Select the Source for Nav Data153
Fish Hunter Option Menu154
Wind Option Menu155
System Setup Menu156
RC (Remote Controller) Setup Menu157
All Clear (Default Setting)157
Appx. 1 Menu Tree159
Appx. 2 Jis Cable Guide164
Specifications165
Packing List167
Index170

Furuno NAVpilot-711C - Page 158

Table of Contents

Other manuals for Furuno NAVpilot-711C

Related product manuals