Furuno NAVpilot-711C User Manual

2. STEERING MODES
2-39
7. Rotate the Course control knob to set the return delay then push the knob.
The setting range is 1-20 seconds.
• NAV mode: When the data from the helm sensor is not input for the set time,
the NAV mode is restored.
• AUTO, WIND mode, etc. (except NAV mode): When cruising straight ahead
and the data from the helm sensor is not input for the set time, the previous
steering mode is restored.
8. Rotate the Course control knob to select [Safe Helm Response] then push the
knob.
9. The cursor is selecting the current value for [Response]; push the Course control
knob.
10. Rotate the Course control knob to select a value then push the knob.
The higher the setting, the faster the response (setting range: 1-10).
11. Press the key to close the [Safe Helm Response] window.
12. Rotate the Course control knob to select the current setting for [Safe Helm Beep]
then push the knob.
13. Rotate the Course control knob to select [ON] or [OFF] then push the knob.
[Safe Helm Beep] turns the beep on or off when the safe helm mode is activated.
14. Press the key three times to close the menu.
Safe Helm Response
Response: 6 PORT STBD
Turn helm to PORT/STBD to set
Safe Helm response time.
Higher value = Faster
response.
Push MENU key to return
Not shown with Fantum Feedback
TM
.
When you turn the helm,
PORT or STBD is highlighted
according to the rudder
direction.

Furuno NAVpilot-711C Specifications

General

Brand	Furuno
Model	NAVpilot-711C
Category	Autopilot System
Language	English