Gamatronic POWER PLUS - Configuring the Batteries to the System

Gamatronic Electronic Industries Ltd.
Power+ Technical Guide 69
6.2.1 CONFIGURING THE BATTERIES TO THE SYSTEM
When you are installing the battery for the first time, or if you have changed either
y the number of battery sets (1 battery set = 64 batteries)
OR
y the total Ampere/hour capacity of your batteries,
you must reconfigure the batteries to the system.
6.2.1.1 TO (RE)CONFIGURE THE NUMBER OF BATTERY SETS:
1. On the system control panel, press Ent.
2. Choose Setup, press Ent.
3. Enter the system password (the default password is eight left arrows),
press Ent.
4. Select Service, press Ent.
5. Select Configure, press Ent.
6. Select # of Batteries, press Ent.
7. Use the up and down arrow keys to modify the number of batteries,
then press Ent.
6.2.1.2 TO (RE)CONFIGURE THE BATTERIES' AMPERE/HOUR RATING:
1. On the system control panel, press Ent.
2. Choose Setup, press Ent.
3. Enter the system password (the default password is eight left arrows),
press Ent.
4. Select Battery, press Ent.
5. Select Capacity, press Ent.
6. Choose the battery set that you want to configure and press Ent.
7. Use the arrow keys to set the desired number of Ampere/hours,
then press Ent.