Garmin GPSMAP 700 - Page 19

GPSMAP
®
700 Series Owner’s Manual 15
Charts and 3D Chart Views
4. Complete an action:
Select AIS Display Range to indicate the distance from your location within which AIS
vessels appear. Select a distance or select Show All.
Select Details > Show to show details about AIS-activated vessels.
Select Projected Heading. Enter the projected heading time for AIS-activated vessels. Select
Done.
Select Trails to show the tracks of AIS vessels. Select the length of the track that appears
using a trail.
Activating a Target for an AIS Vessel
NOTE: The Fishing chart and Mariner’s Eye 3D are available with a preprogrammed BlueChart g2
Vision data card.
1. From the Home screen, select
Charts.
2. Select
Navigation Chart, Fishing Chart, Perspective 3D, or Mariner’s Eye 3D.
3. Touch an AIS vessel.
4. Select
AIS Vessel > Activate Target.
Viewing Information about a Targeted AIS Vessel
You can view the AIS signal status, MMSI, GPS speed, GPS heading, and other information that is
reported about a targeted AIS vessel.
1. From the Home screen, select
Charts.
2. Select
Navigation Chart, Fishing Chart, Perspective 3D, or Mariner’s Eye 3D.
3. Touch an AIS vessel.
4. Select
AIS Vessel.
Deactivating a Target for an AIS Vessel
NOTE: The Fishing chart and Mariner’s Eye 3D are available with a preprogrammed BlueChart g2
Vision data card.
1. From the Home screen, select
Charts.
2. Select
Navigation Chart, Fishing Chart, Perspective 3D, or Mariner’s Eye 3D.
3. Touch the AIS vessel.
4. Select
AIS Vessel > Deactivate.
Setting the Safe-zone Collision Alarm
The safe-zone collision alarm is used only with AIS. The safe zone is used for collision avoidance,
and can be customized. All safe-zone collision alarm settings are applied to all charts and to all 3D
chart views.
1. From the Home screen, select
Congure > Other Vessels > AIS Alarm > On.
A message banner appears and an alarm sounds when an AIS-activated vessel enters the safe-
zone ring around your boat. The object is also labeled as dangerous on the screen. The Off setting
disables the message banner and the audible alarm, but the object is still labeled as dangerous on
the screen.
2. Select
Range to set the measured radius of the safe-zone ring to a specied distance from 500 ft.
to 2.0 nm (or from 150 m to 3.0 km, or from 500 ft. to 2.0 mi.).
3. Select a distance.
•
•
•
•