Garmin GPSMAP 700 - Screenshots; Viewing GPS Satellite Locations; Using WAAS;EGNOS; System Information

GPSMAP
®
700 Series Owner’s Manual 91
Appendix
Screenshots
You can capture as a bitmap (.BMP) le a screenshot of any screen shown on your chartplotter, and
transfer the le to your computer.
Capturing Screenshots
1. Insert a memory card into the SD card slot on the front of the chartplotter.
2. Select
Congure > System > Beeper/Display > Screenshot Capture > On.
3. Go to a screen you want to capture.
4. Press
HOME for at least six seconds.
The Screenshot Taken window appears.
5. Select
OK.
Copying Screenshots to a Computer
1. Remove the memory card from the chartplotter and insert it into an SD card reader that is
attached to a computer.
2. From Windows Explorer, open the Garmin\scrn folder on the memory card.
3. Copy a .BMP le from the card and paste it to any location on the computer.
Viewing GPS Satellite Locations
You can view the relative position of GPS satellites in the sky.
From the Home screen, select Congure > System > GPS > Skyview.
Using WAAS/EGNOS
WAAS (in North America) or EGNOS (in Europe) can provide more-accurate GPS position
information. However, when using WAAS or EGNOS, the device takes longer to acquire satellites.
From the Home screen, select Congure > System > WAAS/EGNOS > ON.
System Information
Viewing System Information
See “Viewing System Information” (page 3).
Viewing the Event Log
The event log shows a list of system events.
From the Home screen, select Congure > System > System Information > Event Log.
Saving System Information to a Memory Card
You can save system information to a memory card as a troubleshooting tool. A Garmin Product
Support representative may ask you to use this information to retrieve data about the network.
1. Insert a memory card into the SD card slot on the chartplotter.
2. Select
Congure > System > System Information > Save to Card.
3. Remove the memory card.