Garmin GPSMAP 700 - Chartplotter Data Management

GPSMAP
®
700 Series Owner’s Manual 57
Device Conguration
Setting the Anchor Drag Alarm
You can set an alarm to sound when you exceed a specied drift distance while anchored.
1. From the Home screen, select
Congure > Alarms > Navigation > Anchor Drag > On.
2. Enter the drift distance that triggers the alarm.
3. Select
Done.
Setting the Off Course Alarm
You can set an alarm to sound when you are off course by a specied distance.
1. From the Home screen, select
Congure > Alarms > Navigation > Off Course > On.
2. Enter the off-course distance that triggers the alarm.
3. Select
Done.
System Alarms
Setting the Clock Alarm
You can set an alarm using the system (GPS) clock.
1. From the Home screen, select
Congure > Alarms > System > Clock > On.
2. Enter the time that triggers the alarm.
3. Select
Done.
Setting the Unit Voltage Alarm
You can set an alarm to sound when the battery reaches a specied low voltage.
1. From the Home screen, select
Congure > Alarms > System > Unit Voltage > On.
2. Enter the voltage that triggers the alarm.
3. Select
Done.
Setting the GPS Accuracy Error Alarm
You can set an alarm to sound when the GPS location accuracy falls outside the user-dened value.
1. From the Home screen, select
Congure > Alarms > System > GPS Accuracy > On.
2. Enter the GPS location accuracy that triggers the alarm.
3. Select
Done.
Setting the Total Fuel Onboard Alarm
The chartplotter must be connected to an external fuel sensor to capture fuel-economy data.
You can set an alarm to sound when the total amount of remaining onboard fuel reaches the level
you specify.
1. From the Home screen, select
Congure > Alarms > Fuel > Total Fuel Onboard > On.
2. Enter the amount of fuel that triggers the alarm.
3. Select
Done.
Collision Alarm
See “Setting the Safe-zone Collision Alarm” (page 15).
Setting Sonar Alarms
See “Sonar Alarms” (page 82).