Garmin GPSMAP 700 - Navigating with a Garmin Autopilot

GPSMAP
®
700 Series Owner’s Manual 35
Navigation
Clearing the Active Track
From the Home screen, select Information > User Data > Tracks > Clear Active Track.
The track memory is cleared, and the current track continues to be recorded.
Managing the Track Log Memory During Recording
1. From the Home screen, select Information > User Data > Tracks > Active Track Options >
Record Mode.
2. Complete an action:
Select Fill to record a track log until the track memory is full.
Select Wrap to continuously record a track log, replacing the oldest track data with new data.
Conguring the Recording Interval of the Track Log
You can indicate the frequency at which the track plot is recorded. Recording more-frequent plots is
more accurate but lls the track log faster.
1. From the Home screen, select
Information > User Data > Tracks > Active Track Options >
Interval > Interval.
2. Complete an action:
Select Distance to record the track based on a distance between points. Select Change. Enter
the distance.
Select Time to record the track based on a time interval. Select Change. Enter the time
interval.
Select Resolution to record the track plot based on a variance from your course. This setting
is recommended for the most-efcient use of memory. Select Change to enter the maximum
error allowed from the true course before recording a track point.
3. Select
Done.
Copying Tracks
See “Chartplotter Data Management” (page 58).
Deleting All Saved Waypoints, Routes, and Tracks
From the Home screen, select Information > User Data > Clear User Data > All > OK.
Navigating with a Garmin Autopilot
When you start navigation (Go To, Route To, or Guide To), if you are connected through a National
Marine Electronics Association (NMEA) 2000 network to a compatible Garmin autopilot (such as
the GHP
™
10), you are prompted to engage the autopilot.
•
•
•
•
•