Garmin GPSMAP 700 - Page 79

GPSMAP
®
700 Series Owner’s Manual 75
Radar
Turning On and Conguring a Radar No-transmit Zone
You can indicate an area within which the radar scanner does not transmit signals.
NOTE
: You can set a radar no-transmit zone for GMR 604 xHD, 606 xHD, 1204 xHD, or 1206
xHD radars only.
1. From the Home screen, select
Radar > Radar Setup > Enable No-transmit Zone.
The no-transmit zone is indicated by a shaded area on the Radar screen.
2. Select
Angle 1 > Adjust > Move.
3. Select
Up or Down to adjust the size of the no-transmit zone.
4. Select
Angle 2 > Adjust > Move.
5. Select
Up or Down to adjust the size of the no-transmit zone.
Front-of-boat Offset
The front-of-boat offset compensates for the physical location of the radar scanner on a boat, if the
radar scanner does not align with the bow-stern axis.
Measuring the Potential Front-of-boat Offset
1. Using a magnetic compass, take an optical bearing of a stationary target located within viewable
range.
2. Measure the target bearing on the radar.
3. If the bearing deviation is more than +/- 1°, set the front-of-boat offset.
Setting the Front-of-boat Offset
Before you can set the front-of-boat offset, you must measure the front-of-boat offset ().
The front-of-boat offset setting congured for use in one radar mode is applied to every other radar
mode.
1. From the Home screen, select
Radar > Radar Setup > Front of Boat.
2. Select and hold
Up or Down to adjust the offset.