11-4 CIC Pro™ 2026419-033E
Reload software
NOTE
In case the reload utility encounters an error (e.g., the USB memory stick
does not contain sufficient memory), try a different USB memory stick with
at least 1 GB of memory, and repeat steps 1 through 6.
NOTE
Depending on the original status of the USB memory stick, at 99% on the
progress indicator, the reload process may appear to be idle. The flashing
LED on the USB memory stick indicates that the program is still processing.
If the USB memory stick is not equipped with an LED, wait for
approximately 5 minutes after the progress indicator shows that the process
is 99% complete.
7. Wait for a message indicating that the operation is complete.
8. Remove the USB memory stick from the service PC.
NOTE
The reload process also prepares the USB memory stick for safe removal
from the service PC. It is not necessary to perform an extra operation to
safely eject the USB memory stick.
9. Close the GE Software Distribution Utility screen.
10. Remove the DVD from the service PC.
To Next Page
Loading...
Need help?
General
