Equipment overview
2026419-033E CIC Pro™ 2-19
Combo mode Example 3:
1. A telemetry bed BED* is admitted and full disclosure data is collected.
2. A hardwire bed BED is admitted and full disclosure data is collected. Two
separate full disclosure data stores exist, one for each bed (possibly on a different
CIC Pro centers).
3. The two beds are put into Combo mode. When this happens, BED* data is kept
because it is older than BED data, and BED data is deleted. Full disclosure data
collection continues, and the data is stored under the name BED.
4. Combo mode is broken by discharging BED*. Full disclosure data collection
continues, and the data is still stored under the name BED.
Combo mode Example 4:
1. A telemetry bed BED* is admitted and full disclosure data is collected.
2. A hardwired bed BED is admitted and full disclosure data is collected. Two
separate full disclosure data stores exist, one for each bed (possibly on a different
CIC Pro center).
3. The two beds are put into Combo mode. When this happens, BED* data is kept
because it is older than BED data, and BED data is deleted. Full disclosure data
collection continues, and the data is stored under the name BED.
4. Combo mode is broken by discharging BED. Full disclosure data collection
continues, and the data is now stored under the name BED*.
Bed name/IP address changes (rover rule)
The CIC Pro center tracks full disclosure data for individual beds using a combination
of the bed name and IP address.
If a bed name changes during full disclosure data collection, information within the
data reflects the new name at the point the name change occurred.
If a bed IP address changes during full disclosure data collection, but the name does
not, it is interpreted as a new and different bed, and a new full disclosure data store is
created and utilized for the new bed.
To Next Page
Loading...
Need help?
General
