76 0000010291
001
6.2.10 Augers
Augers
Attention!
Depending on the rotation direction of the auger, the bolt can have right or
left-handed thread.
1. Take away the air venting pipes. Refer to
section 5.3.2 "Press block".
2. Loosen bolt B.
3. Take away the auger (A). From inside the
hopper, pull back the auger and lift it out.
Rubber bushes
1. Check the rubber bushes (A) for deforma-
tion. Replace in case of deformation.
Assembly
1. Repair or replace the auger.
2. Reassemble the auger in the reverse order.
Make sure the augers are installed in the
right orientation of rotation.
A
B
A
To Next Page
Loading...