GEFRAN-SIEI ARTDrive Vector V2 Series - Page 116

Index MENU [Unit] Access Default Min/Max Format Reg.Mode Level Ipa
Parameter Name
Description
Chapter 6 Parameter • 116 ARTDrive V2 series - Instruction Manual
B0G.02 Std enc supply N/A RWZ 0 0/3 DP V-F-S-B Easy 1927
[0] 5.41 / 8.16 V
[1] 5.68 / 8.62 V
[2] 5.91 / 9.00 V
[3] 6.16 / 9.46 V
Selection between 5V / 8V range is done through dip-switch S28.
Power supply voltage of the standard Encoder input. Increase this value in case of long
encoder cable.
It is possible to select 4 different values of internal encoder supply voltage to compensate
the voltage reduction due to encoder cable length and load current encoder.
Selection available, according to S28 jumper, are: 5.41V, 5.68V, 5.91V, 6.18V and 8.16V,
8.62V, 9.00V, 9.46V via Std enc supply parameter.
B0G.03 Std sin enc Vp [V] RW 0.5 0/1.5 FK V-F-B Full 1902
Peak voltage value of the sinusoidal encoder connected to the standard input.
B0G.04 Std dig enc mode N/A RWZ 0 0/ 1 DP V-F-S-B Full 1931
[0] FP mode Frequency and period measuring mode
[1] F mode Frequency measuring mode
Measuring method of the digital encoder speed connected to the standard input.
B0G.05 Exp enc type N/A RW 1 1/2 DK V-F-B Easy 1926
Encoder type connected to the expanded input port of expansion card installed:
[1]Digital +5V Digital encoder input (select the correct jumper settings on the RV33
regulation card)
[2]Frequency inp Digital single channel frequency input: channel A. Signal +5V must be
connected between A and power supply common.
B0G.06 Exp enc pulses [ppr] RWZ 1024 Calc/Calc FK V-F-B Easy 1900
Encoder pulses per revolution (ppr) value of the expanded input port of expansion card
installed.
B0G.07 Dig spd Fbk Sel N/A RW 0 0/1 DV V-F-B Easy 1940
It allows to switch the feedback between the encoder standard port “XE” (on RV33
regulation card) and the encoder expanded (from encoder optional cards: EXP-F2E and
EXP-D14A4F):
[0] Std encoder Standard encoder input of “XE” port
[1] Exp encoder Expanded encoder input of optional card installed
B0G.08 Speed fbk sel N/A RW 0 0/1 DV V-F-B Full 7058
Command source for the selection of the encoder used for speed feedback; factory