GEFRAN-SIEI ARTDrive Vector V2 Series - Page 122

Index MENU [Unit] Access Default Min/Max Format Reg.Mode Level Ipa
Parameter Name
Description
Chapter 6 Parameter • 122 ARTDrive V2 series - Instruction Manual
B01 STARTUP / Main cmds
B01.00 Commands select N/A RWS 2 0/4 DV V-F-S-B Easy 4002
[0] TerminalLevel The drive is controlled via terminal strip using Level sensitive signals
[1] TerminalEdge The drive is controlled via terminal strip using Edge sensitive signals
[2] DigitalLevel The drive is controlled from a communication or application card using level
sensitive signals
[3] DigitalEdge The drive is controlled from a communication or application card using edge
sensitive signals
[4] I O keys The drive is controlled from the keyboard using the I O keys; terminal 12
(Enable) to 24Vdc are required
NOTE! Setting of this parameter is not allowed while terminal enable is active.
B01.01 Term Local src N/A RWS Ipa4000 Plist 16 PIN V-F-S-B Easy 9212
Ipa 4000 - NULL = Default
It allows to select the signal to obtain the local commands by keypad.
ªª
ªª
ª
Pick List 16
Local/Remote command through digital input
The following picture shows the selection logic for the source of START and STOP
commands:
[1] Local
Command source
selectorC00-20
[2] Digital Level
[1] Terminal Edge
C00-43
C00-03 = Digital input
To d rive command logic
[0]Terminal Level
[0] Remote
[3] Digital Edge
[4] I O Keys
Figure B01.01: Command selection
When the selector (dedicated digital input) is 0 (Remote), Start and Stop commands
come from the source specified by parameter B01.00.
When the selector (dedicated digital input) is 1 (Local), Start and Stop commands come
from the keypad, regardless what is set into parameter B01.00.
The status of the digital selector is read by the drive only when the output of the inverter
bridge is disabled. As a result, it is not possible to switch between local and remote
source for main commands while the motor is running.
NOTE! Normally the Stop key acts as Emergency stop, when the source of main
commands is not the keypad.
For more details, see P.005 parameter description below.