Index
MENUMENU
MENUMENU
MENU [Unit] Access Default Min/Max Format Reg.Mode Level Ipa
Parameter Name
Description
ARTDrive V2 series - Instruction Manual Chapter 6 Parameter • 123
B01.02 Stop key mode N/A RWS (*) 0/1 DP V-F-S-B Easy 3998
Stop key configuration:
[0] Inactive (*): Default for Europe
Standard configuration, where main commands are coming from keypad.
Therefore, the STOP key will cause a normal stop of the motor.
[1] EmgStop & Al (*): Default for American
Pressing the Stop key, the motor will execute an Emergency stop, following
the ramp programmed by Fast Stop deceleration time selected. After the
speed reaches zero, the drive will trip with the dedicated alarm “Key Em Stp
fault”. An alarm reset will be needed to restore drive operations.
See C00.24 parameter description for more details.
B02 STARTUP / Ref src
B02.00 Ramp ref 1 src N/A RWS Ipa5009 PList 7 PIN V-F-S-B Easy 7035
Ipa 5009 - AI 1 output = Default
It select the souce of the signal of Ramp reference 1 signal, which define the main speed
reference of the inverter.
ªª
ªª
ª
Pick List 7
B02.01 Dig ramp ref 1 [rpm] RWS 0 Calc/Calc PV V-F-S-B Easy 7030
Digital ramp reference 1 value.
B03 STARTUP / Acc/Dec
B03.00 Accel time 1 [sec] RWS 10 0.5/10000 PP V-F-S-B Easy 8041
Acceleration ramp time 1.
B03.01 Decel time 1 [sec] RWS 10 0.5/10000 PP V-F-S-B Easy 8043
Deceleration ramp time 1.
B03.02 Fdec time 1 [sec] RWS 10 0.5/10000 PP V-F-S-B Easy 8045
Fast Stop deceleration ramp time 1.
B04 LOADDEF
B04.00 Load default ? Easy
Drive reset with default parameter values in the selected regulation mode only.
NOTE! “Load default ?” command does not reset SETUP MODE with default parameter
values; Drive, Motor data and Autotune values are mantained.
To Next Page
Loading...