GEFRAN-SIEI ARTDrive Vector V2 Series - Page 210

Index
MENUMENU
MENUMENU
MENU [Unit] Access Default Min/Max Format Reg.Mode Level Ipa
Parameter Name
Description
Chapter 6 Parameter • 210 ARTDrive V2 series - Instruction Manual


 SPEED REG / Speed ref
Rubber Calender application example
M
DRIVE A
MASTER =1000 rpm 1050 rpm 1100 rpm
+
LINE SPEED
DRIVE B
DRIVE C
+
Line speed
ratio 1 = ±5%
Line speed
ratio 2 =±10%
AN. INPUT
1
AN. INPUT
1 2
AN. INPUT
1 2
-
+
-
M
M
Example setting:
DRIVE A (master) Set: D00.00 - Ramp ref 1 src = 004-AI 1 output
DRIVE B Set: Line speed ratio 1 = Line speed ±5%
D00.00 - Ramp ref 1 src = 004-AI 1 output
F00.02 - Speed ratio src = 005-AI 2 output
Set in An Inp 2 submenù:
C02.10 - AI 2 type = [0] -10V ...+10V
C02.16 - AI 2 lo lim = 15564 cnt
C02.17 - AI 2 hi lim = 17203 cnt
DRIVE C Set: Line speed ratio 2 = Line speed ±10%
D00.00 - Ramp ref 1 src = 004-AI 1 output
F00.02 - Speed ratio src = 005-AI 2 output
Set in An Inp 2 submenù:
C02.10 - AI 2 type = [0] -10V ...+10V
C02.16 - AI 2 lo lim = 14745 cnt
C02.17 - AI 2 hi lim = 18072 cnt