GEFRAN-SIEI ARTDrive Vector V2 Series - Page 234

Index
MENUMENU
MENUMENU
MENU [Unit] Access Default Min/Max Format Reg.Mode Level Ipa
Parameter Name
Description
Chapter 6 Parameter • 234 ARTDrive V2 series - Instruction Manual


 TORQUE / Torque zero command
NOTE! Menu accessible with Access Level = FULL
The block controls the Zero Torque sets the sum of Speed regulator output + Torque
reference to zero. (Torque reference is referred to Torque ref 1, Torque ref 2 and Torque
ref 3).
The origin of the zero Torque command signal can be selected via the “Zero trq cmd src”
source.
The parameters and the sources included into “Torque” are available only with a
Sensorless and Field Oriented mode.
G03 TORQUE / Trq 0 cmd
G04.00 Zero torque src N/A RWS Ipa4000 PList 3 PIN F-S-B Full 2451
Ipa 4000 - NULL= Default
It select the origin of the signal of Torque zero command.
ªª
ªª
ª
Pick List 3
G04.01 Zero torque mon N/A R 0 0/1 DV F-S-B Full 2452
It displays of the Torque zero command state:
0 = not active
1 = active