GEFRAN-SIEI ARTDrive Vector V2 Series - Page 272

Index
MENUMENU
MENUMENU
MENU [Unit] Access Default Min/Max Format Reg.Mode Level Ipa
Parameter Name
Description
Chapter 6 Parameter • 272 ARTDrive V2 series - Instruction Manual
Card missing No card was found during the initialization (ISBUS enabled)
Heartbeat There has been a heartbeat Timeout
M04.05 ISB FAULT memo N/A R 0 0/0xffff DP V-F-S-B Full 4229
This item shows the last asic FAULT register value found different from 0000 (no error);
the FAULT register value codes are displayed as hexadecimalnumbers:
0001 Invalid page requested in SCELL packet
0002 Host page FIFO underflow or overflow
0004 Illegal SCELL
0008 Frame overrun
0010 Illegal SCELL
0020 Duplicate node
0040 ACELL no response
0080 SCELL no response
0100 ACELL transmit FIFO underflow/overflow
0200 ACELL receive FIFO underflow /overflow
0400 SCELL transmit FIFO underflow/overflow
0800 ACELL receive FIFO underflow/overflow
1000 Received bad SCELL CRC
2000 Illegal symbol
4000 Bus hog error
M04.06 ISB FAULT cnt N/A R 0 0/0xffff DP V-F-S-B Full 4240
This item reports the total number of FAULT register error conditions detected from the
start-up.
M05 COMM / Drv-ISBus
NOTE! Menu accessible with Access Level = FULL
M05.00 Drv ISBus W0src N/A RWS Ipa9320 PList 28 PIN V-F-S-B Full 4230
Ipa 9320 - Dig D- ISBus W0 = Default
Drv ISBus W0src Word 0 channel source on the Drive output.
ªª
ªª
ª
Pick List 28
M05.01 Drv ISBus W1src N/A RWS Ipa9321 PList 28 PIN V-F-S-B Full 4231
Ipa 9321 - Dig D- ISBus W1 = Default
Drv ISBus W1src Word 1 channel source on the Drive output.
ªª
ªª
ª
Pick List 28