GEFRAN-SIEI ARTDrive Vector V2 Series - Page 292

Index
MENUMENU
MENUMENU
MENU [Unit] Access Default Min/Max Format Reg.Mode Level Ipa
Parameter Name
Description
Chapter 6 Parameter • 292 ARTDrive V2 series - Instruction Manual
PID I freeze src
PID FF mon
PID PI enab src
PID PI out mon
PI steady thr
PI Iinit gain
PI steady delay
PI Pinit gain
PI clamp bot
PI clamp top
PID PI Iock mon
PI I notm gain
PI P notm gain
X
+
+
PI P3 gain %
PI P2 gain %
PI P1 gain %
PI I3 gain %
PI I2 gain %
PI I1 gain %
P
I
REF
(REF)
PIGP tran21 band PIGP tran32 band
PIGP tran21 h thr PIGP tran32 l thr
PID FF mon
PI enable
Figure O03-2: PI Control block
The O03.00 - PID PI enab src and O03.01 - PID I freeze src sources allow to select the
origin of the enabling signals (enable/disable) of the PI function and of the freezing
signals of the regulator Integral section.
O03.02 - PIGP ref src selects the input signal of the gain Adaptive; the block function
allows to set a three-segment Profile. In the Block it is possible to select, via an internal
selector, three starting multiplication values: O03.30 - Dig PID Mtl PI 1, O03.31 - Dig PID
Mtl PI 2, O03.32 - Dig PID Mtl PI 3, internal values which can be set in the
configurations.
The O03.12 - PID Mtl PI 3 src source connects standard the value of O03.32 - Dig PID
Mtl PI 3. O03.10 - PID Mtl PI sel 0 and O03.11 - PID Mtl PI sel 1 are the sources
selecting the command signals of the internal selector. According to their condition, it is
possible to state a combination determining the equivalent output factor.
The following table lists the factors corresponding to each different combination:
PID Mtl PI sel 1 PID Mtl PI sel 0 PID Mtl PI sel mon
000*
011Dig PID Mtl PI 1
102Dig PID Mtl PI 2
113**
Tab par O03
* : The last value calculated by the integral component is stoeed
**: The factor connected to the PID Mlt PI 3 src is ACTIVE
Table O03: Output factor combination