GEFRAN-SIEI ARTDrive Vector V2 Series - Page 87

ARTDrive V2 series - Instruction Manual Chapter 5 Quick Start Up Guide • 87
Set the drive main
reference
Set the drive acceleration
and deceleration ramps
time
Save the drive parameters
NOTE!
B STARTUP / B02 Ref src
Enter the B02.00 - Ramp ref 1 src parameter to select
from the list displayed the source of drive speed
reference; selection example:
• 004 - AI 1 output Analog input 1 reference (default)
• 000 - DigRampRef 1 Digital reference 1 value, settable
through B02.01 - Dig ramp ref 1
parameter (see B02 Ref src
menu)
B STARTUP / B03 Acc/Dec
Enter the parameters:
• B03.00 - Accel time 1 to set acceleration time (5 sec =
default)
• B03.01 - Decel time 1 to set deceleration time (5 sec =
default)
[Escape] all drive menu up to B - STARTUP, than press
[Escape] again to display the Save parameters
command, so press [Enter] to confirm the save
execution.
To perform speed loop gain of the speed regulator, see
chapter 7.4.
Operation OperationStep
17
18
16