CAUTION
Electromagnetic radiation due to improper connection of cables
If the product is operated with connecting cables attached at only one of their two ends, for
example external supply cables, interface cables, the permitted level of electromagnetic radia-
tion may be exceeded and the correct functioning of other products may be impaired.
Precautions:
▶
While the product is in use, connecting cables, for example product to external battery,
product to computer, must be connected at both ends.
1.8 FCC Statement, Applicable in U.S.
☞
The greyed paragraph below is only applicable for products without radio.
WARNING
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own
expense.
CAUTION
Changes or modifications not expressly approved by GeoMax for compliance could void the
user's authority to operate the equipment.
19152_001
Complies with FDA performance standards for laser products except for
deviations pursuant to Laser Notice No. 50, dated June 24, 2007.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Pav = 4.8mW λ = 658nm tp = 400ps
IEC 60825-1:2014
Label placement on the
Zoom10
Safety Directions 15
To Next Page
Loading...
Need help?
General
