Selection by number
In this example, pressing 2 on the alphanu-
meric keypad opens the screen for setting
the distance offset.
3.6 Pointsearch
Pointsearch is a function used by applications to find measured or fixed points in the memory
storage.
The pointsearch is limited to the current job. It is not possible to search the whole storage.
By entering an actual point number, for example A1, and pressing softkey Find, all points within
the current job and with the corresponding point number are found.
Example: Search for a station point
Find To search for matching points
within the current job.
Search result
Use the UP/DOWN keys to select a point in
the search result list.
View To display the coordinate and job
details of the selected point.
Coord. To create a point by entering
point coordinates manually.
Job To search for points within
another job.
OK To confirm the selected point .
The wildcard search is indicated by a "*". The asterisk is a place holder for any following
sequence of characters. Wildcards should be used if the point number is not fully known, or to
search for a batch of points.
* All points are found.
A All points with exactly the point number "A" are found.
A* All points starting with "A" are found, for example, A9, A15, ABCD, A2A.
Description
Direct search
Wildcard search
Examples of point
searches
User Interface 23
To Next Page
Loading...
Need help?
General
