2. Search for a point
•
Enter a point ID.
•
Press Find to check if a point with this point ID exists.
•
If there are several points, press the UP/DOWN keys to select a point.
If no point with this point ID exists, enter or measure the coordinates of the
point.
•
Press OK to confirm and return to the Height Transfer screen.
View list of points
•
Press List to display a list of available fixpoints.
•
Press the UP/DOWN keys to select a point.
•
Press OK to confirm and return to the Height Transfer screen.
Enter point coordinates manually
•
Press Coord..
•
Enter a point ID and the coordinates of the new fixpoint.
•
Press OK to confirm and return to the Height Transfer screen.
Measure the known point
1. Aim at the known point.
2. To start measuring and save the measured values, press ALL or DIST+REC.
3. The station height is calculated and displayed in the result screen.
Next step
•
To select and measure another known point, press AddPT.
•
To remeasure the current known point, press Back.
•
To complete the station setup, press OK. Refer to "Complete station setup".
Back To return to Height Transfer screen.
OLD To set the station height to the old
value.
AVG To set the station height to the average
of the old and the new value.
NEW To set the station height to the new
value.
Field Description
Old H0 Old value of the station height.
New H0 New value of the station height, calculated from the measured known points.
∆H0 Average of old and new station height.
7.4 Hidden Point
Hidden Point function is used to measure a point that is not directly visible. It is necessary to use
a special hidden point rod, of which the length is known.
P0 Instrument station
P1 Hidden point
R1 Prism 1
R2 Prism 2
d1 Distance between prism 1 and 2
d2 Rod length
Complete station setup
Description
42 Functions
To Next Page
Loading...
Need help?
General
