Introduction
Congratulations on the purchase of the GeoMax Zoom10.
This manual contains important safety directions as well as instructions for setting up the prod-
uct and operating it. Refer to "1 Safety Directions" for further information.
Read carefully through the User Manual before you switch on the product.
To ensure safety when using the system, please also observe the directions and instructions con-
tained in the User Manual and Safety Handbook issued by the Machine manufacturer.
The content of this document is subject to change without prior notice. Ensure that the product
is used in accordance with the latest version of this document.
Updated versions are available for download at the following Internet address:
https://partners.geomax-positioning.com/downloads.htm
The model and serial number of your product are indicated on the type plate.
Always refer to this information when you contact your agency or GeoMax authorised service
workshop.
•
Windows is a registered trademark of Microsoft Corporation in the United States and other
countries
All other trademarks are the property of their respective owners.
Description
General This manual applies to Zoom10 instruments. Where there are
differences between the models they are clearly described.
Telescope
•
Measuring with P modes: When measuring distances to a
reflector with Electronic Distance Measurement (EDM) mode
"P", the telescope uses a wide visible red laser beam, which
emerges coaxially from the telescope's objective.
•
Measuring with NP modes: Instruments that are equip-
ped with a reflectorless EDM additionally offer the EDM
mode "NP". When measuring distances with this EDM mode,
the telescope uses a narrow visible red laser beam, which
emerges coaxially from the telescope's objective.
Purchase
☞
Product identification
Trademarks
Validity of this manual
2
To Next Page
Loading...
Need help?
General
