Giga-tronics 8003 - Calibrating for Power Measurement

Operation
Manual 20791, Rev. C, June 2001 2-67
2.8.1 Calibrating for Power Measurement
Before the 8003 analyzer can operate, the Power Sensor and Bridge must be calibrated. Connect the
power sensor to the 8003 analyzer front panel connector marked
CALIBRATOR
. You may need to use
an adapter to adapt from the sensor connector to the front panel type N(f) connector. Press Function
[CAL]
and look at the softkey menu.
Press
[ CAL SENSOR ]
to bring up a menu of sensors to be calibrated.
Figure 2-19: CAL Softkey Menu
Figure 2-20: Sensor CAL Menu
SHORT/
OPEN
THRU
CLEAR
PTH CAL
*NF
CAL
SENSOR
ZERO
SENSOR
CAL
KEY
* Used only with
Noise Figure testing
CAL
CALL
ALL
SENSOR
A CAL
SENSOR
B CAL
SENSOR
C CAL
RETURN
CAL