Giga-tronics 8003 - Definition of ASCII Codes

8003 Precision Scalar Analyzers
Index-2 Manual 20791, Rev. C, June 2001
DEFINE MRKR N Softkey
CLEAR ALL MRKRS 2-46
CLEAR MRKR N 2-46
CURSOR FREQ 2-45
DEFINE MRKR N 2-45
MRKR N ON and MRKR N OFF 2-45
Definition of ASCII Codes 3-26
Description 1-1
Device Clear
Channel, Cursor, Sensor, Display, Channel, Source 3-18
Directional Bridges A-4
DISABLE 3-19
Display 3-18
Display Description 2-8
Channel Titles 2-8
Cursor Frequency 2-8
Front Panel Function Key/Remote Light 2-8
Softkey Labels 2-8
Start, Center, CW Frequency 2-9
Stop, Span 2-8
DISPLAY Key 2-24
AVG Softkey 2-24
DISPLAY SETUP Softkey 2-33
GRAPH/READOUT Softkey 2-32
HOLD ON/OFF Softkey 2-26
LIMIT LINES Softkey 2-31
PLOT & PRINT Softkey 2-27
UNITS Softkey 2-32
DISPLAY SETUP Softkey
ALPHA/CURS POS 2-34
CH TTL ON/OFF 2-34
CHANNEL COLOR 2-33
COLOR 2-33
FREQ LBL ON/OFF 2-34
GRAT COLOR 2-33
LABELS 2-33
TITLE 2-34
TITLE ON/OFF 2-34
UNDO/ERR TTL 2-34
DISPLAY STATUS Softkey
DISPLAY CURRENT and DISPLAY PREV 2-48
DISPLAY N 2-48
ds Definition 3-10
E
ENABLE 3-19
Environmental Requirements 1-5
EOL Definition 3-10
Equipment Required 4-6
F
FIXED 3-21
Front & Rear Panel Descriptions 2-1
Front Panel Function Key/Remote Light 2-8
Front Panel Operation (Instructions) 2-66
THRU Softkey
2-37
FUNCTION Controls 2-18
MEAS Key 2-18
SCALE Key 2-22
G
General 4-1
GPIB Interconnect Cable Connections B-5
GPIB Interface 1-13
GPIB Port Check 4-10
GPIB Private Port Check 4-11
GPIB/PRIVATE Interface
Pass Through Feature 3-72
GPIB/Private Port Check 4-11
GPIB/System Port Check 4-10
Graph & Readout Display Modes 2-13
H
Hints on Simplified Scaling 2-86
HP 7090A
HP 7090A Pen Color Format (6 Pens) B-14
HP 7440A
HP 7440A Pen Color Format (8 Pens) B-11
HP 7470A
HP 7470A Pen Color Format (2 Pens) B-13
HP 7475A B-12
HP 7475A Pen Color Format (6 Pens) B-12
HP 7550A
HP 7550A Pen Color Format (8 Pens) B-10
HP Printer Installation
LaserJet Family RS-232 Cable Interconnections B-8
PaintJet Color GPIB Cable Interconnections B-7
ThinkJet GPIB Cable Interconnections B-7
hs Definition 3-10
I
IEEE Bus Interface
Connect the System Controller 3-1
Set the GPIB Address 3-1
INPUT 3-24
Insertion & Return Loss Measurements 2-75
Installation 1-2
Cleaning 1-6
Cooling 1-6
Environmental Requirements 1-5
Items Furnished 1-5
Items Required 1-6
Power Input, Fuse & Voltage Selector 1-3
Power Requirements 1-4
Power Sensor Precautions 1-3
Receiving Inspection 1-6
Safety 1-2
Tools & Test Equipment 1-6
Instrument Plus Power Sensor Linearity 4-7
Setup Parameters 4-8
Test Description 4-7
Test Procedure 4-10, 4-11
Introduction
Operation 2-1
Remote Operation 3-1
System Configuration B-1
Items Furnished 1-5
Items Required 1-6
K
Key Operation
START Key 2-52
STOP Key 2-53
KEYEM, KE 3-25
L
LaserJet Family RS-232 Cable Interconnections B-8
RS-232 Electrical Description B-8
LaserJet Printer Swtc. & Jmpr. Loc. and Sts. B-9
LIMIT LINES Softkey 2-31
ABORT PLOT 2-31
CLEAR ALL SEGMENTS 2-31
DEFINE SEGMENT 2-31
LMT LNS ON/OFF 2-31
PLOT ENTRIES 2-31
SEGMENT N CLEAR 2-31
Line Voltage & Fuse Selection 1-3
Power Sensors 1-3
Power Sensors Accessories 1-3
Line Voltage and Fuse Selection 1-3