Giga-tronics 8003 - SWEEP TIME Key

8003 Precision Scalar Analyzer
2-56 Manual 20791, Rev. C, June 2001
2.6.6 SWEEP TIME Key
[ SWEEP TIME ]
When the SWEEP TIME softkey is pressed, the entry area of the display will again show the currently
defined sweep time. Note that this is the same type of data entry that is allowed when the SWEEP TIME
function key is pressed. The reason for the redundancy is so that it will not be necessary to leave the
softkey menu and go to the Source Control function keys to change the sweep time.
[ INT SWP TRIGGER ]
This function is not currently implemented.