Operation
Manual 20791, Rev. C, June 2001 2-55
[
POWER SWEEP
]
Turns on the Power Sweep function as described in Section 2.14. The following sub-menu softkey
selections will be available (as shown in Figure 2-15):
[
PWR SWP ON/OFF
]
Controls the enabling or disabling (toggle) of the power sweep measurement mode.
[
START POWER
]
Allows the entry of the desired power sweep starting power level (in dBm).
[
STOP POWER
]
Allows the entry of the desired power sweep stopping power level (in dBm).
[
FREQ
]
Allows setup of the desired power sweep operating frequency range.
[
SWEEP TIME
]
Allows setup of the desired analog sweep time.
[
ANALOG/DIGITAL
]
Selects either the analog or digital power sweep mode, as desired.
[
STEP SIZE
]
Allows setup of the digital power sweep step size.
[Sweep Time]
See the description of the UPD SWP ON/OFF softkey section 2.6.4.1.
The SOURCE
[SWEEP TIME]
function key initiates changing of the sweep time. When the
key is pressed, the entry area of the display will show the currently defined sweep time and a menu
similar to that shown below will be displayed.
To Next Page
Loading...
