Giga-tronics 8003 - Rear Panel Inputs & Outputs; BNC Connectors; GPIB Connectors

8003 Precision Scalar Analyzer
1-14 Manual 20791, Rev. C, June 2001
1.5 Rear Panel Inputs & Outputs
1.5.1 BNC Connectors
Sweep In
0 to +10V, nominal (Maximum = 10.75 V).
Blanking Input
Blank the sweep oscillator bandswitching points on the display
Voltage Level: Blanked: >2 V typical
(TTL) Unblanked: <0.8 V typical
V
PROP
F Input
Interface to signal source V
PROP
F output of -10 to +10 Vdc.
Input 1
Used with some sweepers to provide synchronization.
AC Modulation Output
Provides the drive to the modulation input on the sweeper, or to an
external modulator, for use in the ac detection mode.
DAC Output
Not Currently Used.
Bias Output
Programmable output voltage used to display a family of curves.
Voltage Range: ±10 V
Current Compliance: Source or sink 150 mA, maximum.
1.5.2 GPIB Connectors
System GPIB
Used to connect the 8003 to a GPIB controller.
Private GPIB
Used to connects the 8003 to a signal source and plotter.
RS-232 Port
Serial Communication Interface for driving an HP Laserjet printer.