Giga-tronics 8003 - Temperature & Low Level Offset Update Structure; Print Definition Command Structure

Remote Operation
Manual 20791, Rev. C, June 2001 3-49
3.3.22 Temperature & Low Level Offset Update Structure
RDTEMP
Syntax: RDTEMP hs sensor specifier
Specifiers: A, B, or C
Output format for temperature:
dd.d
Assumed units:
degrees C
Description: In the fast CW measurement modes (trigger modes T1 through T3 of the POWER
command), temperature and low level correction are turned off to maximize the measure-
ment speed. At most power levels (>-50 dBm), this causes negligible reading error. At very
low power levels, the RDTEMP command should be used before each fast measurement
run to update temperature and low level offset drift.
If the analyzer is listen addressed immediately after the RDTEMP command, it will also
output the temperature in degrees Celsius for the sensor.
3.3.23 Print Definition Command Structure
PRINT
Syntax: PRINT us modifier EOL
Examples: PRINT;paint;SRQ
PRINT;laser’SRQ
Modifiers: This modifier defines the type of printer to be receiving the raster scan plot as an HP INK
JET PRINTER.
Modifier name: INK
Modifier Syntax: INK
Modifier Description: This modifier defines the type of printer to be receiving
the raster scan plot as an HP PAINT JET PRINTER.
Modifier name: PAINT
Modifier Syntax: PAINT
Modifier Description: This modifier defines the type of printer to be receiving
the raster scan plot as an HP LASER JET+ PRINTER.
Modifier name: LASER
Modifier Syntax: LASER
Modifier Description: Asserts GPIB SRQ at the end of a print routine. The
system controller would normally use an interrupt
service routine to take action once the analyzer asserts
SRQ. An SRQ can be cleared by doing a GPIB serial
poll of the analyzer.