Giga-tronics 8003 - Page 11

Preface
Manual 20791, Rev. C, June 2001 vii
Figure 2-56: 3 Different Methods (CAL Factor Correction Plus Sensor Offsets) .......2-99
Figure 2-57: Averaging Used to Reduce Noise ......................................................2-100
Figure 2-58: Reference Level & Corresponding Relative Reading...........................2-101
Figure 2-59: Menus & Typical Display (Power Sweep Measurements) .................2-104
Figure 3-1: Location of GPIB/System Connection (Rear Panel).................................3-1
Figure 3-2: GPIB Commands (Front) .......................................................................3-8
Figure 3-3: GPIB Commands (Back)........................................................................3-9
Figure 3-4: Plot Obtained Using More Complex HP Series 300 Prg. Example........3-28
Figure 3-5: Limit Line Display Example .................................................................3-63
Figure 4-1: Calibrator Output Test Setup ................................................................4-3
Figure 4-2: Power Linearity Test Setup...................................................................4-7