Giga-tronics 8003 - Page 197

Remote Operation
Manual 20791, Rev. C, June 2001 3-55
Modifier name: MEAS, M, ABS
Modifier Syntax: MEAS
Modifier Description: This modifier defines the measurement to be made in
relative units (meas data - path cal).
Modifier name: NORM, N, -PC
Modifier Syntax: NORM
Modifier Description: This modifier sets the scale factor used for the CRT
graphical swept data display.
Modifier name: SCALE, SC
Modifier Syntax 1: SC ds state
State definition: +CA = continuous auto scale on
-CA = continuous auto scale off
AUTO = auto scale ONCE
Modifier Syntax 2: SC ds numerical value
valid numerical values: 0.1, 0.2, .05, 1.0, 2.0, 5.0, 10, 20
Modifier Description: This modifier defines the reference position for the
measured trace for the 8003 CRT graphic display.
Modifier name: REF_POS, RP
Modifier Syntax: RP ds numerical value
valid numerical value: -4 = bottom of screen
-3 = next graticule up
-2 = next graticule up
-1 = next graticule up
0 = center graticule
+1 = next graticule up
+2 = next graticule up
+3 = next graticule up
+4 = top of screen
All other non-valid numerical values force the setting to center screen.