Operation
Manual 20791, Rev. C, June 2001 2-49
[
CLEAR N
]
First Level Menu F6: Clears both stored setups and all of non-volatile memory. When a setup is
cleared, it is initialized in the same manner that the current setup when [PRESET] is pressed. When
[CLEAR N] softkey is pressed, the entry area of the display will present a prompt to enter the num-
ber of the setup to be cleared.
The softkey menu will change to sub-menu F6-2.
[
CLEAR N
]
Second Level Menu F6-2: Clears an instrument setup that was stored using the [STORE N]
softkey. When [CLEAR N] is pressed, the entry area of the display will present a prompt to
enter the number of the setup to be cleared.
This is the same action that takes place when [CLEAR] is pressed. It is provided here in case
another of the softkeys in the Clear menu has been used, and it is then desired to clear a num-
bered setup.
When the number of the setup to be cleared is entered, the 8003 will clear the stored setup and
indicate in the entry area of the display that it has completed this task. The number of another
stored setup to be cleared can then be entered.
[
CLEAR ALL N
]
Menu F6-2: Clears all stored setups. This does not provide access to clear the current setup or
previous state setup. Press [PRESET] to clear the current setup; press [PRESET] twice to clear
both the current and the previous setups.
The softkey menu will change to offer the option of either Clearing All or aborting the routine.
When the [CLEAR ALL N] softkey is pressed, all of the stored setups are cleared. The entry
area of the display will indicate that the setups have been cleared, and the instrument will
return to the Memory key primary menu (F6).
If the [ABORT CLEAR] softkey were pressed, the routine would return directly to the Memory
key primary menu (F6). The stored setups will not be affected.
[
CLEAR ALL MEM
]
Menu F6-2: Clears all information contained in the non-volatile memory. This includes the
current setup, the previous state setup, all stored setups, all stored traces, and all defined user
tests.
The softkey menu will change to offer the option to either clear all of the non-volatile memory
or to abort the routine.
NOTE:
This action cannot be reversed once accomplished.
☛
☛☛
☛
To Next Page
Loading...
