Gilson 157 - Front Panel; Start up

Operation 3
3-2 Gilson 157/159 UV-VIS Detectors User’s Guide
Front Panel
Front Panel
The front panel of the detector contains a:
flow cell holder
display
Start Up
Follow the instructions in Chapter 2,
Installation, to make all rear panel and
plumbing connections.
Ensure that the detector and the router are
connected to a power source.
Switch the detector ON using the switch on the
rear panel.
• The lamps initialize.
• A self-test and calibration runs.
• The display illuminates.
The detector is now ready to operate.
1
2
Figure 3-1: Front Panel
1
2
Figure 3-2: Start Up Display Example (157 UV-VIS Detector)
Figure 3-3: Start Up Display Example (159 UV-VIS Detector)