Gilson 157 - Creating Program Lines; Deleting Program Lines; Running a Program

Gilson 157/159 UV-VIS Detectors User’s Guide B-7
Front Panel Control B
Program Menu
Creating Program Lines
New program lines can be created while creating a program.
1Touch Tab in the program’s editing window to display the program
lines.
2Touch New to create a new program line.
3 Enter the time value.
4Save setting.
5 Enter value of desired channel.
6Save setting.
Deleting Program Lines
Program lines can be deleted while creating a program.
1Touch Tab in the program’s editing window to display the program lines.
2 Touch to mark the desired program line.
3Touch Del to delete the desired program line.
4 Confirm the query.
5 Touch to go to a higher level, or hold for two seconds to go to the Main menu.
Running a Program
1Touch Program to display the program list.
2 Touch the desired program number and then Load to load the
program.
3 Touch to start the program (Diagram A).
4 Touch to interrupt the program.
5 Touch to stop the program.
6 Touch to repeat the program (Diagram B).
7 Touch to exit the loaded program.
Figure B-7: Creating Program Lines
A
B
Figure B-8: Running a Program