Operation
3
3-8 Gilson 157/159 UV-VIS Detectors User’s Guide
Detector Control from TRILUTION LC
Analysis
Using the options in the Method Builder - Analysis window, you indicate how collected data is analyzed and
reported. TRILUTION LC uses the information in the analysis to report on peaks detected in samples.
To create an analysis, right-click on a data channel in the Configured Instruments Panel and then select New
Analysis.
Application Run
In the Application Run window, specify the list of steps, called a sample list, to execute during a run. A step in the
sample list identifies the method to run. Access the Application Run window by:
• right-clicking an application in the Project Library and then selecting Run or
• selecting an application in the Project Library and then clicking Run or
• opening a saved method in the Method Builder and then clicking Run.
Ensure that the lamp is on before collecting any data, either during your run or while monitoring the baseline
in Manual Control.
After setting up the sample list, click Run in the Application Run window to begin executing the steps in the run.
To Next Page
Loading...
