General hazard – there is a risk of damage to the product if instructions are not followed
Electrical hazard – there is a risk of electrocution or personal injury if instructions are not
followed.
Warnings
Please follow the precautions and instructions indicated below in order to ensure the safety of you and
your environment, and to prevent any potential damage to your device.
WARNING: An isolating switch in compliance with EN60947 standards is used as a
disconnecting device. It must be easily accessible and installed close to the power supply. It
must disconnect all active poles.
The LEDI
®
NETWORK ITS v2m is intended for indoor use only, at an altitude of less than 2000
metres.
Waste disposal by users in private households within the European Union
This symbol on the product or its packaging indicates the product must not be disposed of with
your general household waste. Instead, it is your responsibility to dispose of your waste by
taking it to a designated collection point for the recycling of electrical and electronic appliances.
The separate collection and recycling of your waste contributes to the conservation of natural
resources and helps to ensure that recycling is environmentally and health friendly. For more
information about your nearest recycling centre, please contact the shop where you purchased
your device, the household waste disposal services or your local authorities.
Technical specifications (see chapter 1.4. Clock dimensions)
230VAC 50/60Hz
115VAC 50/60Hz
Low voltage 12, 24 ou 48 VDC
NTP Version: PoE (Power over Ethernet)
Class of electrical equipment
Class 1 (in 115 ou 230 VAC)
Class 3 (in 12, 24, 48 VDC or PoE)
Hygrometry (non condensed)
The product contains a non-replaceable lithium battery.
EXPLANATION OF SAFETY SIGNS ON THE PRODUCT
INTRODUCTIONSOMMAIRE
DU
INTRODUCTION
IO
INSTALLATION RAPIDE
EN
PRINCIPES
GENERAUX
To Next Page
Loading...
