► Daylight Saving Time (DST) policy: LEDI clocks currently support European and North American
time changes. Moreover, it is possible to configure its own DST with the Manual DST parameters
and by setting the Start Date and Stop Date fields. Finally, it is possible to disable DST with the
None selection.
B. Section Hour Display Configuration
► Brightness: the brightness can be adjusted in 10 levels from 1 to 10.
► Digit Color: 3 colors are selectable, Red, Yellow, Green (or White, Cyan, Blue optional) for LED
display color.
► Wave color: 3 colors are selectable, Red, Yellow, Green (or White, Cyan, Blue in option) for the
LED display color of the seconds wave (if present).
► Time/Date/Temperature Display Alternation: This is the display time for each type of information
(time, date, temperature) on the displays.
If the temperature option is activated, the display can alternate between time, date and temperature
according to the number of seconds entered for each of these elements.
If a time is set to 0, then the corresponding data will not be displayed in the loop.
If the temperature option is deactivated but a non-zero time has been set, the data displayed will
be " --.- ".
C. Calendar Display Configuration (if enable) Section
Warning: the "Calendar Display Configuration" section is only accessible for products with a
date display, such as the LEDICAs.
► Langage: This configuration concerns only the Date display and allows you to change the
language of the month display.
N.B: Over 10 languages are currently supported including English, French, German, Italian, Spanish,
Russian, Flemish, Dutch, Scandinavian and Catalan.
► Brightness: the brightness can be adjusted in 10 levels from 1 to 10
► Month/Year Display alternation: The display can alternate between month and year according to
the time given in seconds for each element.
If one time is set to 0, the data will not be displayed in the loop.
If both times are set to 0, the clock will freeze on one of them in an undetermined way.
D. Synchronization point behavior Section
This section concerns only the behavior of the central points of the hour-minute-second displays.
By default, the 2 central points flash at the rate of the second if the clock is synchronized.
► Type: If 'Blinking points' is checked, the 2 center points blink at the rate of one second.
If 'fixed points' is checked, the 2 center points do not blink.
► Behavior: If 'Alight if synchronized' is checked, the two center points are lit only when the clock is
synchronized.
If 'Alight if not synchronized' is checked, the two center points are only lit when the clock is not
synchronized.
If 'Always alight' is checked, the two center points are always lit regardless of the clock's
synchronization status.
To Next Page
Loading...
