FC4500-UM-251-9370 116
7 ELECTRICAL SECTION
(19) The following menu is displayed.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
X ADJ.SENS POS Y
+X +Y
(20) Place a new printed cross mark target on the writing panel to adjust the Y of registration mark
sensor.
(21) Press the [F3] (Y) key to display the following menu.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
MOVE TO ADJ. POINT
PRESS ENTER KEY!
(22) Move the tool position to the following area of printed cross mark target by using the position keys.
Printed Cross Mark Target
Move the tool position to this area.
(23) Press the [Enter] key. The plotter will detect the printed cross mark target with a sensor, and then
plotter draws the cross mark to the detected position.
Offset of Y direction
Printed Cross Mark Target
Offset of X direction
The plotter draws this cross mark
after the Printed Cross Mark was
detected.
(24) The following menu is displayed.
FORCE
SPEED
OFFSET
QUALITY
F1 F3
F4
F2
SENSOR OFFSET ADJUST
X=0.00
mm
Y=0.00mm
To Next Page
Loading...
