GRAPHTEC FC 4500 Series - 5 List of Tools

FC4500-UM-251-9370 10
3 THE TREE STRUCTURE OF MENUS
PAUSE Menu Conguration
The number is showing for the section number of the user’s manual, see the details for each function from
the user’s manual.
TOOL U/DMARK
BUFFER CLR.
20,20 COND1 09U 0 30 PAUSE+ TOOL1 4
FUNCTIONI/F
AREA OPTTOOL COND
CUT LINETHICK
ADJ.T POSTOOL No.
COMMANDRS-232C
DIST ADJMODE
OTHER SETUPSTYPE
ADJ. SENSSIZE
SENS OPTORG OFT
FREQUENCY
SENS STEPSENS SPD
ADJUST SENSOR
LEVELPOSITION
SHORT L.THICK No.
OVERLAY
B.G. SETTINGS
SORTINGDIST. ADJ
MIRRORROTATE
SCALEL.L. U.R.
OPTION2OPTION1
OFST ANGSTART FCE STP PASSOFST FCE
POS.OPTUP HEIGHT
TESTMOVE SPD
HI SPEEDSTEP
LOW SPEED LCD
SELF TEST
DUMPCOND. PAT.
5.26 Printing the Self-Test Pattern
5.27 Printing a Character Dump List5.25 Printing a Conditions List
5.23 Setting the Tool
Movement Speed
5.22 Setting the Tool-up Height
5.21 Setting the Step Pass5.19 Setting the Offset Force
5.18 Setting the Initial Cutting Force
5.16 Setting the Mirror Mode
5.17 Scaling the Image Data5.15 Setting the
Cutting/Plotting Area
5.14 Rotating the Coordinate Axes
5.28 Special Functions
5.13 Sorting5.12 Setting the Distance
Adjustment Values
5.5 Setting the Data
Format to be Received
5.4 Setting the Communication Conditions
5.7 Setting the
Overlay Function
5.6 Assigning
THICK Mode
5.8 Assigning the Short
Line Segment Settings
5.10 Assigning
Perforation Cutting
5.11 Setting the Tool Interval
Adjustment Value
5.9 Assigning Tool Numbers
5.3 Raising/Lowering the Tool
5.2 Clearing the Buffer
CHAPTER 4 Registration Mark Settings and Detection
5.24 Setting the Pen Carriage
Movement Speed
[NEXT] key [NEXT] key [NEXT] key
[NEXT] key
5.20 Setting the Offset Angle
The number is shown for the user’ s manual