FC4500-UM-251-9370 76
6 REPLACEMENT PROCEDURES
(10) Loosen the two M3L8 binding head screws adjusting the Rear X Belt Tension.
Rear X Belt Tension Bracket
Rear X belt tension adjustment screw
(M3L8 binding head screw)
(11) Remove the two Cap screws holding the Rear X Belt Stopper plates, and then detach the Rear X
Belt.
Rear X Belt
Rear X Belt Stopper Plate
Rear X Belt Stopper Plate
Cap screw
(12) Put the some spacer under the Y bar to keep height of the rear of Y bar.
The Front X Slider Roller and the front X rail will be damaged when the Y bar height was not kept.
Put the some spacer to keep the Y bar height.
(13) Remove the two M4L8 cap screws holding the rear of Y bar and the Rear X slider.
Rear X Slider
M4L8 cap screw
(14) Slide out the Rear X slider from the rear of Y bar.
To Next Page
Loading...
