GRAPHTEC FC9000-140 - Page 106

4-16
It will copy in following order when ROTATE is set.
Data that includes registration marks cannot be copied.
It is cross-cut at this position.
Origin point
First cut
Copy origin point
First copy
Cross cut margin
Third copy
Second
copy
Copy
space
Copy
space
Cross cut
margin
Operation
1
Plot (cut) the data you want to copy once.
Cutting data is stored in the buffer memory.
2
Press the POSITION ( ) keys and move the tool
carriage to the position to copy.
Supplement

Turning MEDIA CHANGE MODE on will
display the CHANGE MEDIA message each
time after a single cut.
"If the [ESC] key (QUIT COPY) is pressed,
copying will be suspended and it will return to
the default screen.

When exchanging media, the media selection
will be chosen from what was selected
before copying.

If there is no data in the buffer memory,
"There is no data for copying in the buffer" will
be displayed. Please send cutting data.

If too much data is sent from the buffer
PHPRU\FRS\LQWKH&RS\PRGHEXIIHU
will be displayed.
3
Press the [COPY] key
COPY MODE screen is displayed.