GRAPHTEC FC9000-140 - Setting the Origin Point

3-7
3.3
Setting the Origin Point
Point where the cutting starts is called origin point. The origin point can be set at any location.
New origin
point
Original origin point
How to set the current position to the new origin point
1
Move the tool to the new origin point by pressing the
POSITION (
) keys when it is in READY status.
2
Press the [ORIGIN] key.
1HZRULJLQSRLQWLVFRQÀUPHGDQG1(:25,*,132,17,66(7LV
displayed for few seconds in the screen.