GRAPHTEC FC9000-140 - Take-Up Operation Is Performed Arbitrarily; Roll Media Is Loosely Taken up

18-20
Take-up operation is performed arbitrarily
Possible Cause Solution Reference
Sensor response does not stop. Make sure that the sensor unit is not
blocked by media or a basket.
Preparing to Cut (Take-up)
Roll media is loosely taken up
Possible Cause Solution Reference
Media is strong resilient. Put tension on the roll media by inserting
a paper core with the same width into the
slack part that can be done at the time of
take-up. The swell may stop.
Preparing to Cut (Take-up)
The paper core for take-up runs idle. Make sure that the stopper of the media
JXLGHDQGWKHPHGLDÁDQJHIRUWDNHXS
DUHÀUPO\VHFXUHG
Preparing to Cut (Take-up)