GRAPHTEC FC9000-140 - Setting a Separator; GP-GL Separator

13-14
13.7
Setting a Separator
5HJDUGLQJWKHVHSDUDWRUVHWWLQJVWKHFRPPDQGWKDWLVVHWDVVHSDUDWRULVMXGJHGDVWKHGDWDEUHDNZKHQLWLV
sent. All data up to the data break will be plotted, after it, cross cut will be performed.
GP-GL separator
Set the separator at GP-GL.
Reference
This setting will be saved even if the power is shut off.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the POSITION ( ) key (I/F).
INTERFACE screen (1/4) is displayed.
3
Press the POSITION ( ) key.
INTERFACE screen (4/4) is displayed.
4
Press the [2] key (GP-GL SEPARATOR).
GP-GL SEPARATOR screen is displayed.