GRAPHTEC FC9000-140 - Default Chapter; Preface; Notes on this Manual; Registered Trademarks

I
Preface
Thank you for choosing a Graphtec FC9000 Series Cutting Plotter. The FC9000 Series Cutting Plotters employ
DGLJLWDOVHUYRGULYHV\VWHPWRDFKLHYHKLJKVSHHGDQGKLJKSUHFLVLRQFXWWLQJ,QDGGLWLRQWRFXWWLQJPDUNLQJÀOP
and other media, an FC9000 series plotter can also be used as a pen plotter. To ensure high cutting quality and
optimal productivity, be sure to read this User's Manual thoroughly prior to use.
Notes on this Manual
(1) No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any
means, without the prior written permission of Graphtec Corporation.
7KHSURGXFWVSHFLÀFDWLRQVDQGRWKHULQIRUPDWLRQLQWKLVPDQXDODUHVXEMHFWWRFKDQJHZLWKRXWQRWLFH
(3) While every effort has been made to provide complete and accurate information, please contact your sales
UHSUHVHQWDWLYHRUQHDUHVW*UDSKWHFYHQGRULI\RXÀQGDQ\XQFOHDURUHUURQHRXVLQIRUPDWLRQRUZLVKWRPDNH
other comments or suggestions.
(4) Not with standing the stipulations in the preceding paragraph, Graphtec Corporation assumes no liability for
damages resulting from either the use of the information contained herein or the use of the product.
Registered Trademarks
All names of companies, brands, logotypes, and products appearing in this manual are the trademarks or
registered trademarks of their respective companies.
Copyright
This User's Manual is copyrighted by Graphtec Corporation.