GRAPHTEC FC9000-140 - Setting Cut Line Pattern

7-15
7. 5
Setting Cut Line Pattern
Lines can be cut with perforated lines so the cut parts will not fall off. There are 8 different patterns of perforated
lines set as 0 to 7, and the ratio of cut and uncut part differs in each (tool is raised or the force is decreased for
following length every 8 mm of the cut). The uncut part becomes shorter with smaller value, making it easier to
separate the cut parts.
3DWWHUQPP3DWWHUQPP3DWWHUQPP3DWWHUQPP
3DWWHUQPP3DWWHUQPP3DWWHUQPP3DWWHUQPP
In addition to above 8 patterns, "OFF" which cuts by the solid line without perforation patter and "USER" where
user can specify a unique pattern are provided.
7KHSURFHVVLQJLQWKHSDUWLVQRWFXWZLWKSHUIRUDWLRQSDWWHULVDGMXVWHGLQUP MODE".
The perforation patter can be set for each condition number.
Supplement

Normally use it with default value OFF. It will cut with solid line.

Use Tool Holder (forward) when cutting with any perforation pattern (aside from turning it off).
Flange
Seen from above
Bracket to hold
tool
Tool holder
(Backward: Half cutting/Plotting Pen)
Tool holder
(Forward: Using cutting)
Tool holder

'RLQJDFXWRXWFXWWLQJRXWZLWKDSHUIRUDWHGSDWWHUQLQVWHDGRIDQRUPDOÀOPFXWKDOIFXWWLQJFDQGDPDJHWKHFXWWLQJPDWDQGWKH
quality of a normal cut. Please make sure to use Tool Holder (backward).

Replacing a cutting mat that was damaged by doing a perforated cut with use of Tool Holder (backward) will require a service fee.

When the tool number is switched between the Tool No. 1 and the Tool No. 3 using the command from the computer, the following
message will appear.
Please follow the message's instructions.

The cut on the perforation pattern is shortened by 5 mm on the +X side (back of the media).