2-22
2.7
How to Use Control Panel
This section explains the function of lamps and keys on the control panel.
[1] key
BARCODE
key
PAUSE/MENU
lamp
ORIGIN key
[2] key
PAUSE/MENU
key
[4] key[3] keyScreen (LCD) SLOW key POSITION
key COND./TEST key
COPY key
ESC/CROSS CUT key
ENTER key
Indicator lamp
PAUSE/MENU lamp
............................ When in MENU mode, the lamp lights up.
Operation key
BARCODE .................. The continuous operation start screen of data link will be displayed. In Apparel (AP)
Mode, it is disabled.
PAUSE/MENU ............ Switches to the MENU mode.
It will go into MENU mode if it is pressed once, and MENU mode will be turned off when
it is pressed again.
Different function are set in the MENU mode.
When the PAUSE/MENU key is pressed during the operation, the cutting/plotting
operation stops.
ORIGIN ....................... It will set the current position as an origin point.
On the READY screen, pressing the [ENTER] and [ORIGIN] keys at the same time will
allow you to reset the machine. (Only in Normal mode)
COPY ......................... Copy of data in the buffer memory is output.
ESC/CROSS CUT ...... (ESC): Cancels the setting change and then returns to the previous screen. Returns to
the previous screen in the MENU screen.
(CROSS CUT): In the READY status, detach the media on which cutting/plotting is
completed.
ENTER ....................... Saves the settings, and then returns to the setting screen in various function or
CONDITION setting screen of the MENU screen.
On the READY screen, pressing the [ENTER] and [ORIGIN] keys at the same time will
allow you to reset this machine.
To Next Page
Loading...
